(image for) CHECK ORDER STATUS
(image for) All CLIP Holsters Ship in 24 Hours

CLIP Holster Claw Kit (For CKC CLIP Holster)

  • Model: clipclaw

(image for) Ask a Question

$14.99

Add to Cart:

CLIP Holster Claw Kit (For CKC CLIP Holster)


Compatible with All NEW Cleveland Kydex IWB CLIP Holsters. (Must have at minimum 2 mounting holes at bottom)


Say Goodbye to Printing forever with our new IWB CLIP Holster Claw Kit!


Looking for Maximum Concealability? Our reversible claw kit is here to help. The Claw pushes the butt of your sidearm towards your body to minimize any printing for maximum concealability.


Compatible with Cleveland Kydex IWB CLIP Holsters (Must have at minimum 2 mounting holes at bottom).


This kit contains all the hardware you need to add the claw to your holster, and works with both Right Handed and Left Handed Cleveland Kydex IWB CLIP Holsters (Must have at minimum 2 mounting holes at bottom).


(Kit includes: 1 reversible claw base, 1 short claw standoff, 1 tall claw standoff, 1 flat screw, 1 nut, 2 rubber bushings, 2 short screws, 2 long posts)




INSTALLATION INSTRUCTIONS;


1 - Line up CLAW mounting holes on mounting holes of holster (Strut comes up outside edge of trigger guard portion of holster).


2 - Install Hardware (Screws and Posts) to secure CLAW mounting holes to CLIP Holster mounting holes at bottom (Posts from behind holster, and Screws from top, into posts, securing CLAW strut to holster). The included rubber bushings should be used between these two items prior to screw installation.


3 - Pick Height option for CLAW pad (Two are included, and can be used based on preference/body type. They will apply less or more pressure on backside of pant/belt, forcing sidearm grip closer to body).


4 - Install hexagonal lock nut from behind strut into recessed portion (Installed from rear to receive screw from front). Install desired CLAW pad height option from front while holding rear lock nut in place. Install Screw from front, through CLAW pad hole, and into lock nut held in rear of strut, to complete installation.





FOR FACTORY INSTALLATION:


MUST HAVE COMPATIBLE HOLSTER IN CART AT TIME OF PURCHASE





*Note - Only compatible with CKC CLIP System IWB Holsters.


** It is recommended to place BLUE LOCTITE on all screws once desired mount position has been identified.


*** It is recommended to use the provided rubber bushings (x2) in between the CLAW strut and holster. Bushings will increase longevity, and decrease effect of vibrational loosening of attachment hardware over time.


**** Any hardware must be checked from time to time for proper tightness by user. CKC is not responsible for lost hardware.


(image for) fedex

(image for) Free Shipping

Payment Processing






(image for) usa

(image for) MILITARY - LEO - EMS

(image for) 3days
Payment Processing
Copyright © 2024 The Cleveland Kydex Co